ALMOST FORGOT

HYDRAULIC PRESS UPDATE:

Sometime in early June there was some time available to put the hydraulic press that we had acquired from George back together. After getting the hydraulic ram re-built and tested it needed to be reinstalled into the press and have the top and bottom beds re-installed. It may not be visible in these pics, but there is a 1/2 inch piece of plate steel inbetween the frame and the wooden bed on the top and the bottom. The one on the bottom is even more massive because of the large stiffening flanges that are welded to the collar and the 1/2 inch plate steel. The collar merely sits on top of the hydraulic piston. The ram is actually a 50 ton bottle jack that has an auxillary port.

Via that aux port you can put pressurized hydraulic fluid directly under the piston and run the press. For now, it is just operating with the jack via the jack handle - you know, the old fashioned way! But it's good enough to allow for testing temporarily. Sometime

in the fall we will build a small hydraulic power

pack to run the press more practically. During our test runs we will look to see how much pressure is required to press the pieces that we need to make. This will determine how big (psi) system we will need. As you might image, it also determines how much $$$ it will take to build that system - the higher the PSI the more the $$$ needed to build it.